Model | 2/320W |
Product Name | UV Electronic Ballast / UV Lamp Driver |
Lamp Quantity | 2 lamps (2×320W, 2 lamp outputs) |
Input Voltage | AC230V, 50/60Hz |
Single Lamp Power | 320W |
Lamp Current | 2.1A |
Compatible UV Lamp | GPHHA1554T6L, TUV325XPT, NNI300/147XL Amalgam UV Lamp |
Working Ambient Temp | 0 ~ 40 ℃ |
Max Case Temp | ≤70℃ |
Warranty | 12 months (under normal operation) |
Application | Water disinfection, wastewater treatment, UV sterilizer, aquaculture, air oxidation |
dvantages
Independent Dual Fault Detection Two separate monitoring loops, no mutual interference. It is the key function for automatic UV disinfection equipment.
High Heat Dissipation Structure Stainless steel slotted shell, good thermal conductivity, suitable for non-stop industrial working condition.
Optimized Ignition Circuit for Amalgam Lamp Amalgam UVC lamp requires special starting curve. This ballast provides stable preheat start, reduces lamp damage rate.
Safety Grounding Required Ground terminal on housing, meet EU industrial safety standard.
Wiring Diagram Description
Power input terminals: L, N Group 1: Output & fault contact for lamp 1 Group 2: Output & fault contact for lamp 2 Fault contacts are dry contact, cannot carry heavy load directly.
Typical Application
Municipal & industrial wastewater UV disinfection systems
RO pure water / ultra-pure water sterilizer
Aquaculture, fish pond water disinfection
Swimming pool & recreational water treatment
Waste gas UV photolysis & oxidation equipment
Important Safety Instructions
Cut off mains power before installation or service
The ballast case must be connected to protective earth
Do not use this ballast for lamp power other than 320W amalgam lamp
Do not confuse single lamp version (1×320W) and dual lamp version (L248-2/320W). Same outline dimension but different circuit.
Do not install in enclosed cabinet without air circulation.
